ARDUINO BASED DC MOTOR SPEED CONTROL

  • Hirdesh Kr. Saini
  • Shahid Firoz
  • .Ashutosh Pandey
DOI: https://doi.org/10.53555/eee.v3i4.273
Keywords: ARDUINO, BASED, DC, MOTOR, SPEED, CONTROL

Abstract

The Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again. "Uno" means one in Italian and was chosen to mark the release of Arduino Software (IDE) 1.0. This is called a boot loader. The ATmega328 on the Uno comes preprogrammed with a boot loader that allows you to upload new code to it without the use of an external hardwar programmer. It communicates using the original STK500 protocol we can also bypass the boot loader and program the microcontroller through the ICSP (In- Circuit Serial Programming) header using Arduino ISP B. 8 channel

Downloads

Download data is not yet available.

Author Biographies

Hirdesh Kr. Saini

Student of Electrical Engineering Department

Shahid Firoz

Student of Electrical Engineering Department

.Ashutosh Pandey

Student of Electrical Engineering Department

Published
2017-12-30
How to Cite
Saini, H. K., Firoz, S., & Pandey, .Ashutosh. (2017). ARDUINO BASED DC MOTOR SPEED CONTROL. IJRDO - Journal of Electrical And Electronics Engineering, 3(4), 01-05. https://doi.org/10.53555/eee.v3i4.273
Issue
Vol. 3 No. 4 (2017): IJRDO - Journal of Electrical And Electronics Engineering
Section
Articles

Author(s) and co-author(s) jointly and severally represent and warrant that the Article is original with the author(s) and does not infringe any copyright or violate any other right of any third parties, and that the Article has not been published elsewhere. Author(s) agree to the terms that the IJRDO Journal will have the full right to remove the published article on any misconduct found in the published article.